Effect of nitrogen flow ratio on microstructure, mechanical and tribological properties of TiWSiNx thin film deposited by magnetron co-sputtering

Rok publikacji: 2018
Wydawca:  Applied Surface Science, 2018, 456, 445-456
Zobacz publikację
H. A. Macías, L. Yate, L. E. Coy, J. J. Olaya, W. Aperador
We investigate the deposition of TiWSiNx thin films by means of the method of reactive magnetron co-sputtering, setting the nitrogen flow ratios N2/(Ar + N2) at 4.8%, 9.1%,16.7 and 33.3%. The crystallographic structure of the films was established through X-ray diffraction (XRD), the morphology and topography were evaluated through scanning electron microscopy (SEM) and atomic force microscopy (AFM), the chemical composition was evaluated through X-ray diffraction and X-ray photoelectron spectroscopy, the mechanical properties were evaluated by nanoindentation, and the wear resistance was studied via nanowear and pin-on-disk. It was found that films deposited between 4.8% and 16.7% nitrogen flow ratio exhibited an amorphous phase. As the nitrogen was increased, the films evolved into a mixture of amorphous Si3N4 and crystalline TiWN phase. Moreover, the film morphology changed to fine columnar as the nitrogen flow ratio increased. As a general observation, the hardness, resistance to plastic deformation (H3/E2), and residual stress of the samples increased as the nitrogen flow ratio increased. The maximum hardness, resistance to plastic deformation, and residual stress were 22 ± 0.4 GPa, 213 ± 20 MPa, and 1.4 ± 0.01, respectively. The lowest nanowear volume (0.47 µm3) and wear rate (11 ± 8 10−9 mm3/N mm) were obtained for films deposited at high nitrogen flow ratios. The lowest friction coefficient (0.15) was recorded for films deposited at 16.7% nitrogen flow ratio.

Kontakt | Baza kontaktów | RSS | Login
© 2022 CENTRUM NANOBIOMEDYCZNE UAM | ul. Wszechnicy Piastowskiej 3, PL 61614 Poznań, Poland | tel.+48 61 829 67 04.